Appropriate Operation of Hot Air Stenter

Marketplace for buying and selling other digital goods with no specified category.
Post Reply
hotairstenterlicheng
Posts: 2
Joined: Wed May 15, 2019 8:18 am

Wed May 15, 2019 8:24 am

Our Hot Air Stenter is a machine or apparatus for stretching or stentering fabrics. The purpose of this machine is to stentering, drying and heat-setting used for cotton, wool, linen filament, silk, knitted or woven fabrics auxiliaries padding. In order to improve work efficiency, it’s of great importance to know appropriate operation of the machine, which is also beneficial to the maintenance of the machine and increase service life. The right operations of our hot air stenter are as follows:
1. Check the mechanical, electrical, instrumentation and safety protection devices before turning on the machine. According to the process requirements, set the temperature, and then turn on the circulating fan. During the heating stage, the host speed is 15m/min, and the cloth cannot be put until the set temperature is reached. After meeting the requirements, open the active brush wheel, press the cloth on the needle plate, try to make both sides flush, and at the same time put down the passive brush wheel and tighten the fabric. When starting the host, you should first ring the bell to inform the tail operator. When you put it to the rear of the car, you should put on the cloth at the fastest speed and tighten the fabric. The rear personnel should cooperate with each other.

2. Regularly check the heat transfer oil pipeline in the oven. If there is oil leakage, we should deal with in time. Before and After your shift, the fly flower should be cleaned, and the fly and oil in the exhaust pipe should be cleaned regularly to eliminate the fire hazard.

3. Add a steam pipe on the exhaust pipe at the top of the oven, which can be cooled by steam. When the temperature inside the machine reaches 165℃, the steam valve should be normally open; the heat sink is equipped with a wire mesh cover to prevent flying flowers from burning on the heat sink.

4. When cleaning or refueling, you must turn off the machines. It is strictly forbidden to smash the chain, brush the needle plate, and rub the roller (especially the upper and lower rolling bars). Be careful to injure fingers. When cleaning on or in the machine or repairing, you must hang the parking sign on the console to prevent others from injury.

Zhejiang LICHENG Printing&Dyeing Machinery Technology Co.,Ltd as a professional hot air stenter machine and Flat Screen Printing Machine manufacturer, we have a strong R&D team,and we can develop and produce priting machine products according to the drawings or samples the customers offered. If you interested in our products, please feel free to contact us by click https://www.hotairstenter.com/product/f ... chine.html
Post Reply